The lock comes preset with one unique default Programming Code.
SCHLAGE KEYPAD DEADBOLT CODE
Red blinking indicates critically low battery CodesĬontrol of the lock is simply managed via a six-digit Programming Code and four-digit User Codes.The color of the Schlage button indicates the status of the lock. We don’t recommend them because they don’t give you a lot of time to change your batteries before the lock is completely dead. Lithium batteries may have a longer life, but when they begin to fail, they fail quickly. Open the battery compartment and replace the battery.Use a high-quality alkaline 9 volt battery for replacement. This will ensure continued reliable operation.
Place the batteries in your lock at the same time each year that you test and replace the batteries in your smoke alarms. The Flex Lock (FE595) is normally locked from the outside, but can be set to unlocked by putting the thumbturn in the vertical position. The Auto Lock (FE575) is always locked from the outside. What is the difference between the Auto Lock and the Flex Lock? See Changing the Battery on page 9 or Restore Factory Settings on page 15 for more information The key cannot be removed from the cylinder while the lock is unlocked. * Rotate the key back to starting position to relock. Key Override can be used when the battery is completely dead, or when no valid User Code is known.
* No User Code is required to open the door when the lock is set to unlock.
Rotate the thumbturn back to the horizontal position to re-lock. Rotate the inside thumbturn to the vertical position.*. » If lighting is low, Press the Schlage button to illuminate the keypad before beginning. Keypad locks are always locked from the outside, by default. Use a small flathead screwdriver to rotate the lock override slot to LOCKOUT. When engaged, a key must be used to unlock the lock. Lock Override can be used to completely disable the keypad. See Changing the Battery on page 6 or Restore Factory Settings on page 15 for more information. Hold the thumbturn still while removing the key. Rotate the thumbturn 90° toward the hinges. Push the key and cylinder into the thumbturn. Key Override can be used to gain access when the battery is completely dead, when no valid User Code is known or when Lock Override is engaged. Re-tuck wires so they will not be crimped. Replace the batteries in your lock at the same time each year that you test and replace the batteries in your smoke alarms. Rotate the thumbturn toward the hinges. » If lighting is low, press the Schlage button to illuminate the keypad before beginning. See Enable or Disable Lock & Leave on page 12. * If the Turn Lock feature is disabled, a valid User Code must be entered to lock the door. Rotate the thumbturn away from the hinges. MODEL BE365 Locking and Unlocking From the outside FE595 ONLY: Used to put the lock in a locked or unlocked state. Used only in emergency situations to unlock the lock. The outside lever can be rotated at any time, but will only retract the latch when the lock is unlocked. The inside lever can be rotated at any time to retract the latch. Programming Guide on page 10 and Locking and Unlocking on page 8 for more information. Used to enter codes for programming and unlocking. Models FE575 (Auto Lock) and FE595 (Flex Lock) Used to unlock the lock after a valid User Code has been entered, or to lock the lock after the Schlage button has been pressed. See Programming Guide on page 10 and Locking and Unlocking on page 6 for more information. For technical documents and videos, visit
0 kommentar(er)
